Router-CIM Automation Suite

RCIM_2020_Header


RCIM_2020_Header


Previous topic Next topic  

RCIM_2020_Header


Previous topic Next topic  

Ramp Feedrate

 

Ramp_Feedrate

 

This sets ramp feedrates when a cut is doing multiple passes. The default is 1.0, Router-CIM's standard 100% feedrate for ramp down when doing multiple passes.

 

Note: Ramp Feedrate parameter will only affect CNC machines using G-Code as the NC code format.

 

Setting the parameter to a number less than 1.0 is a percentage of max feedrate set in the Control Panel.

Setting the parameter to a number greater than 1.0 will give you an exact feedrate.

 

Setting the Ramp Feedrate to 180 on a cut where the normal feedrate is 600, would allow the feedrate to be slower on the ramp down than normal.  Normally the lead in would be 600 but in this case when a ramp is created between multiple passes in a cut, it will ramp down at a feedrate of 180 instead of the default 600.

 

You could also have set the Ramp Feedrate to 0.3 which is 30% of the programmed feedrate or 180 as well.