Router-CIM Automation

CutSim_Header

CutSim_Header
This is the first topic This is the last topic  

CutSim_Header
This is the first topic This is the last topic  

Installation Guide

 

Local users will need Administrator privileges to install the software.

 

The CutSim program is installed in the following manner:

 

Insert the CutSim Installation DVD and it will start automatically. If it does not start automatically, pick Start > Run then pick or type D:\setup.exe (where D: is the DVD ROM drive letter).

 

The install will search for CutSim 2015 files in the default location. If your version of CutSim was installed to a drive other than C, you can re-direct the setup process to locate the folder in the proper drive by clicking on Browse and then selecting the correct drive location.

 

When the installation program starts, the following screen will appear:

 

Install_Start

 

Select 'Next' to continue.

 

Install_License

 

This is the license agreement for CutSim 2015. Be sure you read the agreement. Selecting ‘I do not agree to the terms of this license agreement’ will allow you to exit the program without installing it to your computer. Selecting Back will return you to the previous window. Select ‘I agree to the terms of this license agreement’ and 'Next' to continue.

 

 

Install_Folder

 

 

This screen will recap where CutSim 2015 is going to be installed to. You may select 'Next' to continue, or either 'Back' to go to the previous window or 'Cancel' to exit from the installation.

 

 

 

Install_RemoveExist

 

The next screen will ask if you would like to remove any older versions of CutSim. You can check the checkbox for "Yes, please remove old version before preceding" if you wish to remove old versions of the code. You can leave the checkbox blank if you do not wish to remove the older installs.You may select 'Next' to continue, or either 'Back' to go to the previous window or 'Cancel' to exit from the installation.

 

 

Install_Progress

 

The installer will start copying files to the necessary locations in this section of the install.  As soon as this is finished, you will see the following screen:

You will see a message requesting you to reboot your computer.  The installation is not finished until you reboot your computer.

 

 

Install_Success

 

Once CutSim is finished installing, the last screen will appear. Select 'Finish'.