Adjusting Pin Trim Variables for Two-Sided Nesting

 

To adjust the variables that affect the two-sided nesting PIN_TRIM function, you will need to add the following variables to the Router-CIM NCVAR file. To learn how to add variables to NCVARs, click here.

 

Add the variables exactly as shown:

 

*pin_trimamt*

*pin_offset*

 

*pin_trimamt* - Changes the extension amount of the pin trim cut in the Y axis. Default value is 14.

*pin_offset* - overrides the distance of the cut from the edge. The top-side NC code file will be offset by this amount. Default is ½ the edge allowance of the nested material.